We are searching data for your request:
Balloon pump, qualatex balloons, and sharpie
Inflate one balloon to approx 10" and tie off remaining balloon . Inflate second balloon to approx 22" (leaving approx 5" tail)
Cut off excess balloon (from the short one only) after tying off
Make a chain of 4 bubbles- approx 2", 2", .5", 2".
Twist together bubbles # 2 & #4 . Always twist 3 times (in the same direction)
Twist a half inch bubble and hold it while you twist the next bubbles...
3 bubble chain with .5" , 1.5" , 1.5". These are the neck and front legs.
Twist together the two 1.5" bubbles (again in the same direction and 3 times)
Twist a 2" section for the tummy and hold it while you twist the legs
Make a 3- bubble chain 2", 1.5", 1.5". Twist the two 1.5" bubbles together for the back legs as you did for the front legs. Make sure that something is left for the tail.
Straighten out all the groups of bubbles
Twist the tail in half- making sure to leave a bubble against back legs to hold it together (and be the back end)
Squeeze top bubble into uninflated portion of the balloon
If possible, tie off top bubble
Here we are... ready for the ears
Take bubble at the top of the head - lift and squeeze the bubble, while gently twisting 3 times in the same direction
It should look like a bean
View from the front
Take second balloon and fold in half
And twist at the center ...
Attach to top of head at connection made by pinch twist
Gently give the ears a little shape by bending in half and then releasing
Do both ears
Add artwork w/ sharpie and voila! a cute little balloon puppy dog
Copyright Balloon Utopia tm 2012. Www.balloonutopia.com